Product Information
Force Turbos pump fuel turbo system is designed specifically for all Polaris General® 1000 units and Polaris General® 1000 XP units.
With a boost level of 5 psi and high-volume design, you are sure to get the additional horsepower you are looking for with minimal stress on the motor. Your General will see a dramatic horsepower increase to the wheels from 68hp to near and above 105hp.
This system will fit all 2 door and 4 door Polaris General models.
Turbo system includes the following:
- Garrett Turbo
- Dynojet® Powervision 3 with tune
- 2.5” aluminum charge tube & cold air intake
- 4 ply silicone connection fittings
- Stainless steel high flow turbo supply pipe and exhaust components
- All necessary fittings, hoses, clamps, and hardware
- Turbo system does not include clutch kit (options available if needed)
*** If your vehicle is going to be used in deep water, or deep mud please upgrade the oil scavenge pump to the waterproof model. ****
Off-Road Use Only
QUESTIONS & ANSWERS
Ask a Question-
With this work with the dura clutch and the Gilloman tune
Hello,
The product will work with the dura clutch after adding some more weight.
The Gillomen tune that you have will not work with our turbo system.
The turbo uses a different strategy and didffent sensor that are not complatable with other tunes.
With our turbo system we supply you with a dyno jet fuel controller and a new tune to work with the turbo system .
Please call us with any other questions.
Thank you
-
Does it come with or can you put a pop off valve on it?
The Turbo system does not come with a BOV (Blow Off Valve) But is could be added if you would like.
-
do you need to have a upgraded clutch to run this?
No, you can run the stock clutch. But, you will need to change the clutching componets ( spring and clutch arms) to control the over rev conditions and shift proper with the extra horse power.
We can supply a clutch set up that will get you going. -
It states that it is 100 HP stock. Have you Dyno'd one of these with this Turbo kit on it to see the performance increase?
Polaris has stated the stock horsepower on the Polaris General is 100 HP at the crank. On average, you lose 30%-40% of power through the clutching, transmission, and axels. That is why, we always state our horsepower at the wheel. We have dynoed many Polaris Generals on a Dyno Jet dyno our findings have shown the rear wheel stock horsepower at 65-68 RWHP. With our Force Turbos Polaris General Turbo System, the rear wheel horsepower levels hit 105-109 RWHP at 5 Psi of boost on the same dyno.
Polaris
- General 1000 (2016-2024)
- General 4 1000 (2017-2022)
- General XP 1000 (2020-2024)
- General XP 4 1000 (2020-2024)
Tai with Force Turbos shows you how to install the Force Turbos Polaris General Turbo System.
Performance Expectations
- The system takes your General from 68hp at the wheels to near or above 120hp.
Tuning
- Base fuel mapping included. Digital fuel controller tuning required for specific machine setup for optimum functionality.
- For diagnostics and tuning AFR and Boost gauges recommended.
Boost Level
- 6 psi low-pressure high-volume.
Fuel Considerations
- 91 octance non-ethanol fuel is compatible.
System Exhaust
- High flow performance resonator.
Support
- Our experienced staff is available Monday through Friday from 9 am - 5 pm MST to assist with any of your technical questions.
